logo

Could not compile stylesheet for simplistic. Using last compiled stylesheet.

How to connect e-con Systems e-CAM32_OMAP

posted in Uncategorized
Tuesday, June 14 2011, 10:54 AM
0
Hi We have bought e-con Systems e-CAM32_OMAP_GSTIX camera module. I need ISSE help in connecting it to board and Drivers intrgration. e-con systems has provided driver source which related to gumstix overo as V4l2 module. Regards Krishna
Responses (8)
  • Accepted Answer

    Wednesday, June 22 2011, 07:12 AM - #permalink
    0
    Hope somebody replies.
    The reply is currently minimized Show
  • Accepted Answer

    mcaro
    mcaro
    Offline
    Wednesday, June 22 2011, 09:29 AM - #permalink
    0
    Hi If you need direct support from ISEE then you should contact us directly Manel
    The reply is currently minimized Show
  • Accepted Answer

    Wednesday, June 22 2011, 07:07 PM - #permalink
    0
    Hi, i am not asking help in writing drivers. I need hints for connecting camera to HW. Regards Krishna
    The reply is currently minimized Show
  • Accepted Answer

    mcaro
    mcaro
    Offline
    Wednesday, June 22 2011, 07:22 PM - #permalink
    0
    Ok so: IGEPv2 camera connector = Gumstix camera connetor Manel
    The reply is currently minimized Show
  • Accepted Answer

    leoaran
    leoaran
    Offline
    Wednesday, September 21 2011, 11:13 AM - #permalink
    0
    Hi, I would like to know if I can use the e-CAM32 OMAP GSTIX camera module directly with the IGEPv2 or I need the expansion board for this purpose. Regards. Leo.
    [b]mcaro wrote:[/b]
    Ok so: IGEPv2 camera connector = Gumstix camera connetor Manel
    The reply is currently minimized Show
  • Accepted Answer

    Wednesday, September 21 2011, 11:30 AM - #permalink
    0
    Not directly, you need at least a minimal expansion board to adapt the IGEP v2 camera connector to the e-CAM32 OMAP GSTIX connector. OTOH, the e-CAM32 OMAP GSTIX connector is compatible with the IGEP MODULE cam connector.
    The reply is currently minimized Show
  • Accepted Answer

    leoaran
    leoaran
    Offline
    Wednesday, September 21 2011, 11:36 AM - #permalink
    0
    You mean that connectors are different (mechanically) and the minimal expansion board simply connects lines from one connector to another, isn\\\'t? I have been reviewing the hardware reference manual and it doesn\\\'t seem to me that electrically is compatible. Maybe I am wrong... Leo.
    The reply is currently minimized Show
  • Accepted Answer

    Wednesday, September 21 2011, 02:41 PM - #permalink
    0
    I\\\'m in doubt about power supply but cam signals should be the same.
    The reply is currently minimized Show
Your Reply

SUPPORT


This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.
IGEP Community Wiki
IGEP Community Forum
IGEP Community Online Chat